What this beacon is
This guide is a map of the AT2 documentation for beacon users. The AT2 reference guide stays the source of truth: when in doubt, it wins.
In one sentence
The Industrial Manageable ATEX Beacon is an Abeeway compact tracker (same ATEX hardware), running the standard AT2 firmware, with a short configuration that turns it into a BLE beacon supervised over LoRaWAN.
Compact tracker hardware (ATEX)
+ AT2 firmware (same as every AT2 tracker)
+ Beacon configuration (14 lines, see "Configuration explained")
= Industrial Manageable ATEX Beacon
There is no "beacon firmware". Everything the beacon does is a standard AT2 feature, so every AT2 page applies. Most of them are simply not relevant to you.
What the beacon uses
| Feature | What it does for you | AT2 reference |
|---|---|---|
| BLE beaconing | Advertises an iBeacon (or Eddystone UID, AltBeacon, Quuppa) frame continuously | BLE beaconing, parameters |
| LoRaWAN supervision | Sends a heartbeat every 10 minutes, carrying the battery level and temperature | Heartbeat, common header |
| Remote configuration | Any parameter can be changed with a LoRaWAN downlink | Parameters configuration |
| Accelerometer | Advertises faster for a few seconds when the beacon is moved | Motion detection |
| Reed switch (magnet) | Activation, BLE connectivity advertising or reset | Reed switch interface |
| Temperature monitoring | Optional alerts on high or low temperature | Temperature monitoring |
| Battery estimation | Battery % computed from the estimated consumption | Power consumption |
What you can ignore
The beacon runs in standby mode and never geolocates itself. You can skip everything about:
- GPS, Wi-Fi and BLE scanning geolocation, and geolocation strategies
- Tracking modes (motion tracking, permanent tracking, start/end, activity)
- Position messages, collections, geozoning
- SOS, angle detection, shock detection, proximity
When you read an AT2 page, mentally replace "tracker" with "beacon", and skip any section about positions.
How you configure it
| Channel | Casing | When to use it |
|---|---|---|
| LoRaWAN downlink (recommended) | Closed | Day-to-day changes, fleet-wide changes, on site in a hazardous area |
| CLI over USB | Open | Lab, bench preparation, in a safe zone only |
| Configuration file | Open | Flashed together with the firmware (Abeeway Updater) |
The Beacon configuration tool generates the commands for all three channels.
Next step
Getting started: from unboxing to a supervised beacon.